Laboratory Equipment Details
Complete information about this device
Device Gallery
Available
Reservations
0Views
44Overall service quality rating
0/5
Information about devices and laboratories is clear and updated
0/5
The device search interface is effective
0/5
Steps to request the use of a device are clear
0/5
Devices are in good working condition
0/5
Contributes to obtaining accurate research results
0/5
Devices are available at the required times
0/5
Response to inquiries in a timely manner
0/5
Technical support is qualified
0/5
Contributed to the completion of research
0/5
Recommend your colleagues to use the service
0/5
Device Information
Device Name
Digital Lab Trainer
Model
1
Units Available
1
Manufacture Year
Manufacturer Website
Description
It is a training unit that gives us continuous efforts of different values, as it gives a signal generator and helps the trainee in operating electronic circuits. IDL-800 Digital Logic trainer will be important for our use. Notice the red and orange wires on the left side. These pins are where the Vcc power for the breadboard should be connected. All of the chips in the kit run on +5V, and therefore the power line should always be connected to the +5V power supply. Similarly, the ground line should always be connected to GND. Notice that the +5V and GND pins in the lower left corner supply a variable voltage between +5V and GND and should NOT be used for the supply voltage.
Services & Pricing
| Service | Cost |
|---|---|
| - |