Model IN-601 IN-601 (Digital) Capacity 34, 53, 75, 90, 110, 150 L Control system Analog Microprocessor Temp control ON / OFF PID Temp setting Analog Digital Temp readout Thermometer Digital Air convection Natural (Gravity) Forced convection Temp uniformity ±5.0ºC at 37ºC ±3.0ºC at 37ºC Temp stability ±3.0ºC at 37ºC ±1.0ºC at 37ºC Over-temp alarm & shutout At 80ºC 4ºC to the set point Timer Mechanical, 180 min + HOLD Temperature range Ambient + 5ºC to 75ºC Standard accessory 2 S/S mesh shelves, adjustable Key Features: (IN-601 (Digital)) - Timer is working only when the set temperature has been stabilized. Functions audible & visible alarm against the over heating. - Adjustable fresh air inlet port at bottom and top provides control of the amount of convective air. - Built-in module temperature controller provides an accurate temperature display - Safety devices: - Over temperature alarm and shutout to 4ºC above set point. - Independent safety switch protects specimen from excessive heating at 80ºC if the primary control fails. - Optional leakage breaker with O.C. - Audible & visible alarm indicated by lamp - Timer is displayed by “END” when the incubation cycle is completed. When alarm is working. - Memory stores the temperature and the past time if door is opened during operation IN-601 - This model is used when the samples can’t be disturbed by air current and also for use when the accurate temperature and uniformity are not critical important to users. - A mercury thermometer is mounted on top of the equipment providing temperature direct reading. - Comes with hydraulic thermostat sensor. - The door lock is newly designed easy to lock and open. - The formed door gasket is efficient to prevent the heat loss